Advant
®
Controller 450 User’s Guide
Section 5.5.17 Loading of Application Program
3BSE 002 415R701 Rev A 5-85
Example of Procedure
Action Response
1.
Set the start mode selector on the
P
rocessor Module PM511 front in 3 (CLEAR)
2. Check that the program card is in position.
The system software will be reloaded at the
cold start.
3. Depress the ENTER button The controller system configuration and the
application program are erased.
The processor module will indicate P2 after
about a minute.
4. Set the s
tart mode selector in 1 (AUTO)
Do not p
ress the ENTER button!
5. Connect the communication cable between
the engineering station and the Processor
Module PM511, port X10.
6. Switch on the power supply to the Successful Advant Station 100 Series ES
engineering station boot Windows start up.
7.
If necessary start Application Builder in Appropriate node found.
AdvaBuild window to select project and
node.
8. Start On-line Builder from within the Booting engineering board
Application Builder or in AdvaBuild Press <Ctrl>, <Break>
window.
9. Press <Ctrl>, <Break>
to activate the engineering tool.
10. Select 1 (Advant Cont
roller 400) <CR>
11. Select 1 (Advant Controller 400 programming)
<CR>
12. In the node Setup window confirm or Contact with target.
select the correct Target System. Identity presented.
13. Type LDIR SRCE:*.AD<C
R>to
check that your DUAP dum
p is available. In the example the following
ABCD0001.AD
ABCD0002.AD etc.
are listed.
14. Type LOAP <dump name>, SRCE <CR> The loading proceed. #
For example LOAP ABCD, SRCE<CR>
15. DICONFIG <CR> OK TO START UP THE TARGET, Y/N
16. Type Y <CR>
After about one minute:
THE TARGET SYSTEM IS NOW IN
OPERATION MODE
The processor module will now indicate P1 (OPERATION mode) on the character display.
To Next Page
Loading...
