ABB DCS550 - Change to Edit Mode; Dwl Ap; Important Keys and Buttons; Program Modes

116
AP
3ADW000379R0501 DCS550 Manual e e
DWL AP
General
Another way to create applications is with DWL AP. It is a program plugged into DWL and can be opened with
Tools and DriveAP for DCS550:
Important keys and buttons
Control DWL AP by means of following keys and buttons:
Keys and buttons
Function
Ctrl + left mouse button on a box or function
block
Change / insert function blocks, connect in- and outputs in
Edit mode
Shift + left mouse button on the red cross
View actual values in Start mode
Cancel
Abort the action
Help
Open the online help
Program modes
There are 5 modes, see AdapProgCmd (83.01):
− Stop: AP is not running and cannot be edited,
− Start: AP is running and cannot be edited,
− Edit: AP is not running and can be edited,
− Use SingleCycle and SingleStep for testing.
Change to Edit mode
Use Ctrl + left mouse button on 83.01 Adaptive Program Control and set to Edit:
Insert function blocks
Use Ctrl + left mouse button on one of the yellow boxes. This opens the pop-up window Insert / Change /
Remove Block: