ABB DCS550 - Before Installation; Delivery Check; Unpacking the Unit; Mechanical Installation

19
Mechanical installation
3ADW000379R0501 DCS550 Manual e e
Mechanical installation
Chapter overview
This chapter describes the mechanical installation of the DCS550.
Unpacking the unit
−
Open the box,
−
take out shock dampers,
−
separate manual and
accessories.
Attention:
Do
not lift the drive by the
cover!
Delivery check
Check that there are no signs of damage. Before attempting installation and operation, check the information
on the nameplate of the converter module to verify that the unit is of the correct type. The label includes an
IEC rating, cULus, C-tick (N713) and CE markings, a type code and a serial number, which allow individual
identification of each unit. The remaining digits complete the serial number so that there are no two units with
the same serial number. See an example nameplate below.
N713
ABB Automation Products GmbH
U
1
3
∼
525 V
U2
610 V
Made in Germany
Type: DCS550-S02-0075-05-00-00
I1
62 A
I
2
75 A
Ser No: 0025421A10524264
f1
50/60 Hz
I
f
18 A
SCCR
65 kA
Fan
----
Production year
2010 and week 52
Before installation
Install the drive in an upright position with the cooling section facing a wall. Check the installation site
according to the requirements below. Refer to chapter Dimensions
for frame details.
Requirements for the installation site
See chapter Technical data for the allowed operation conditions of the drive.
Wall
The wall should be as close to vertical as possible, of non-flammable material and strong enough to carry the
weight of the unit. Check that there is nothing on the wall to inhibit the installation.
Floor
The floor or material below the installation must be non-flammable.
Free space around the unit
Around the unit free space is required to enable cooling airflow, service and maintenance see chapter
Dimensions
.
Rated input voltage
Rated input current
Rated output current
Rated internal field exciter
current
Rated fan voltage