43
Electronic board details
3ADW000379R0501 DCS550 Manual e e
Terminal description
− Connectors X1 to X5 provide the standard digital and analog connection of the drive.
− Use connector X9 or slot1 for R-type extension I/O modules and R-type fieldbus adapters.
− Use connector X11 or slot3 only for R-type extension I/O modules.
− Connectors X12 and X13 connect the SDCS-CON-F to the SDCS-PIN-F for voltage, current and
temperature measurement. Additionally the firing pulses are sent to the thyristors trough the SDCS-PIN-F.
− Use connector X33 to connect the DCS Control Panel either directly via a 40 mm jack plug or via a CAT
1:1 cable with RJ45 plugs.
− Use connector X34 for firmware download, to connect DriveWindow Light, commissioning assistant and
DriveAP tool. Usually use the RS232 interface for parameter setting and commissioning the drive via
DriveWindow Light.
− Use connector X37 to connect the SDCS-CON-F to the power supply from the SDCS-PIN-F.
− A seven-segment display named H2500 is located on the control board SDCS-CON-F to show the state of
drive. It displays for example fault- and alarm codes. A detailed description of the seven-segment display is
available in chapter Status messages
.
To Next Page
Loading...
