ABB DCS550 - Start; Stop Select; Parameters

181
Signal and parameter list
3ADW000379R0501 DCS550 Manual e e
Parameters
Signal / Parameter name
min.
max.
def.
unit
Group 10: Start / stop select
10.01 CommandSel (command selector)
UsedMCW (7.04)
selector:
0 =
Local I/O Drive is controlled via local I/O.
Reset (10.03) = DI6; UsedMCW (7.04) bit 7, default
OnOff1 (10.15) = DI7; UsedMCW (7.04) bit 0, default and
StartStop (10.16) = DI8; UsedMCW (7.04) bit 3, default
1 =
MainCtrlWord drive is controlled via MainCtrlWord (7.01)
2 =
Key Automatic switchover from MainCtrlWord to Local I/O in case of F528 FieldBusCom
[FaultWord2 (9.02) bit 11]. It is still possible to control the drive via local I/O. OnOff1
(10.15) = DI7; UsedMCW (7.04) bit 0, default and StartStop (10.16) = DI8; UsedMCW
(7.04) bit 3, default. The used speed reference is set by means of FixedSpeed1 (23.02).
Notes:
−
Local control mode has higher priority than the selection made with CommandSel (10.01).
−
The commands Off2 (10.08), E Stop (10.09) and Reset (10.03) are always active (in case they are
assigned) regardless of CommandSel (10.01) setting.
Int. Scaling: 1 == 1 Type: C Volatile: N
Local I/O
Key
Local I/O
-
10.02 Direction (direction of rotation)
Binary signal for
Direction. Direction (10.02) allows to change the direction of rotation by negating the speed
reference in remote operation:
0 =
NotUsed default
1 =
DI1 1 = Reverse, 0 = Forward
2 =
DI2 1 = Reverse, 0 = Forward
3 =
DI3 1 = Reverse, 0 = Forward
4 =
DI4 1 = Reverse, 0 = Forward
5 =
DI5 1 = Reverse, 0 = Forward
6 =
DI6 1 = Reverse, 0 = Forward
7 =
DI7 1 = Reverse, 0 = Forward
8 =
DI8 1 = Reverse, 0 = Forward
9 =
DI9 1 = Reverse, 0 = Forward, only available with digital extension board
10 =
DI10 1 = Reverse, 0 = Forward, only available with digital extension board
11 =
DI11 1 = Reverse, 0 = Forward, only available with digital extension board
12 =
MCW Bit11 1 = Reverse, 0 = Forward, MainCtrlWord (7.01) bit 11
13 =
MCW Bit12 1 = Reverse, 0 = Forward, MainCtrlWord (7.01) bit 12
14 =
MCW Bit13 1 = Reverse, 0 = Forward, MainCtrlWord (7.01) bit 13
15 =
MCW Bit14 1 = Reverse, 0 = Forward, MainCtrlWord (7.01) bit 14
16 =
MCW Bit15 1 = Reverse, 0 = Forward, MainCtrlWord (7.01) bit 15
Int. Scaling: 1 == 1 Type: C Volatile: N
NotUsed
MCW Bit15
NotUsed
-