ABB DCS550 - Notices

301
Fault tracing
3ADW000379R0501 DCS550 Manual e e
Notices
A notice is a message to inform the user about a specific occurrence which happened to the drive.
Text on DCS Control
Panel
Definition / Action
718 PowerUp
Energize electronics:
The auxiliary voltage for the drives electronics is switched on
719 FaultReset
Reset:
Reset of all faults which can be acknowledged
801 APNotice1
User defined notice by AP
802 APNotice2
User defined notice by AP
803 APNotice3
User defined notice by AP
804 APNotice4
User defined notice by AP
805 APNotice5
User defined notice by AP
ParNoCyc
Cyclic parameters:
A
non-cyclical parameter is written to (e.g. the overriding control writes cyclical on a
non
-cyclical parameter). The parameters causing the notice can be identified in
Diagnosis (9.11).
PrgInvMode
AP not in Edit mode:
Push or Delete action while AP is not in Edit mode. Check:
−
EditCmd (83.02)
− AdapProgCmd (83.01)
PrgFault
AP faulty:
AP faulty. Check:
− FaultedPar (84.02)
PrgProtected
AP protected:
AP is protected by password and cannot be edited. Check:
− PassCode (83.05)
PrgPassword
AP wrong password:
Wrong password is used to unlock
AP, Check:
− PassCode (83.05)
FB found
R
-type fieldbus adapter found:
R-type fieldbus adapter found
Modbus found
R
-type Modbus adapter found:
R-type Modbus adapter found
COM8 found
SDCS-COM-8 found:
Communication board SDCS-COM-8 found
AIO found
Analog extension module found:
Analog extension module found
DIO found
Digital extension module found:
Digital extension module found
Drive not responding
Drive not responding:
The communication between drive and DCS Control Panel was not established or was
int
errupted.
Check:
− Change the DCS Control Panel
− Change the cable / connector which is used to connect the DCS Control Panel
to the SDCS-CON-F
− Change the SDCS-CON-F
− Change the SDCS-PIN-F