ABB HP CP500 - Page 6

10.5 Close the door of the power cabinet...................................................................................65
10.6 Open the door of the charge post....................................................................................... 66
10.7 Remove the plinth covers of the charge post....................................................................66
10.8 Remove the protection plate of the charge post..............................................................67
10.9 Close the door of the charge post....................................................................................... 67
11 Generic procedures........................................................................... 69
11.1 Install a cable lug on a wire....................................................................................................69
11.2 Install a ferrule on a wire........................................................................................................69
11.3 Install insulating heatshrink tubing on a wire................................................................... 70
11.4 Connect a wire that has a cable lug......................................................................................71
11.5 Connect a wire that has a ferrule..........................................................................................71
12 Technical data.................................................................................... 72
12.1 EVSE type...................................................................................................................................72
12.2 Parts included in the delivery................................................................................................ 72
12.3 Required tools for installation.............................................................................................. 73
12.4 Required parts for installation..............................................................................................73
12.5 General specifications............................................................................................................74
12.6 Electrical installation requirements (Europe)....................................................................75
12.7 DC output specifications....................................................................................................... 76
12.8 Logic interfaces specifications.............................................................................................76
12.9 Current peaks during the start of a charge session (DC output).................................. 77
12.10 Mass and center of gravity.....................................................................................................77
12.10.1 Mass........................................................................................................................... 77
12.10.2 Center of gravity, power cabinet......................................................................... 77
12.10.3 Center of gravity, charge post............................................................................. 78
12.11 Tilt sensor specifications (option).......................................................................................78
12.12 Ambient conditions.................................................................................................................78
12.13 Noise level................................................................................................................................. 79
12.14 Torque specifications.............................................................................................................79
12.15 Dimensions...............................................................................................................................80
12.15.1 Power cabinet..........................................................................................................80
12.15.2 Charge post............................................................................................................. 80
12.15.3 Height of user operable elements....................................................................... 81
12.16 Space requirements................................................................................................................ 82
12.16.1 Power cabinet..........................................................................................................82
12.16.2 Charge post..............................................................................................................83
12.16.3 Charge post: exceptions for bollards and other minor fixed obstacles......84
12.16.4 Distance requirements between power cabinet and charge post............... 85
12.17 Foundation specifications.....................................................................................................86
12.17.1 Power cabinet (prefab concrete).........................................................................86
12.17.2 Power cabinet (custom)........................................................................................90
12.17.3 Charge post (prefab concrete).............................................................................91
Contents
6 9AKK107992A6488-EN | 004