NoteAction
WARNING
Used oil is hazardous material and must be
disposed of in a safe way. See section De-
commissioning on page 381 for more inform-
ation.
7
Remove the oil dispenser.8
Tightening torque:Refit the oil plug, draining.
Note
Before refitting the oil plug in the gearbox,
always replace the oil plug gasket with a
new gasket. If not there is a risk of leakage.
9
Other design than Type C: 3-8 Nm
Type C: 24 Nm
xx1800001138
Tightening torque: 24 NmRefit the oil plug, venting.10
Different position due to design differ-
ences:
xx1800001137
xx1800001139
See Inspection and repair of surface
treatment on page 150
If the robots paint coat is damaged during
the procedure, paint touchup is needed.
11
Continues on next page
Product manual - IRB 4600 Foundry Prime 157
3HAC040585-001 Revision: M
© Copyright 2013-2018 ABB. All rights reserved.
3 Maintenance
3.5.2 Changing the oil, axis 1 gearbox on floor mounted robots
Continued
To Next Page
Loading...
