ABB IRB 4600 Foundry Prime - Inspecting the Mechanical Stop Pin, Axis 1

3.4.8 Inspecting the mechanical stop pin, axis 1
Location of mechanical stop pin, axis 1
The mechanical stop pin is located on the frame as shown in the figure.
A
B
xx0800000298
Fixed stopA
Mechanical stop pin, axis 1B
Required equipment
NoteArticle numberEquipment
See Spare part lists on
page 399.
Mechanical stop pin axis 1
Content is defined in section
Standard tools on page 393.
Standard toolkit
These procedures include
references to the tools re-
quired.
Other tools and procedures
may be required. See refer-
ences to these procedures in
the step-by-step instructions
below.
Additional equipment - Foundry Prime
NoteArticle numberEquipment
Mercasol3HAC034903-001Rust preventive
3HAC026759-001Sikaflex 521FC
12340011-116Loctite 574
Brush
Continues on next page
Product manual - IRB 4600 Foundry Prime 135
3HAC040585-001 Revision: M
© Copyright 2013-2018 ABB. All rights reserved.
3 Maintenance
3.4.8 Inspecting the mechanical stop pin, axis 1