3.5.6 Changing the oil, axis-4 gearbox
Location of oil plugs
The axis-4 gearbox is located in the front of the upper armhouse.
The oil plug is shown in the figure.
xx0800000307
Oil plug, for filling and drainingA
Required equipment
NoteEquipment
Where to find information of the type of oil,
article number and the amount in the gear-
box, see section Type of lubrication in gear-
boxes on page 151
Lubricating oil
The capacity of the vessel must be sufficient
to take the complete amount of oil.
Oil collecting vessel
Used for venting the gearbox during draining.
A suitable hose would be a hose normally
used for compressed air.
Plastic hose
Length: minimum 300 mm. Diameter: 5 mm.
xx1200000862
Funnel
Continues on next page
Product manual - IRB 4600 Foundry Prime 177
3HAC040585-001 Revision: M
© Copyright 2013-2018 ABB. All rights reserved.
3 Maintenance
3.5.6 Changing the oil, axis-4 gearbox
To Next Page
Loading...
