ABB IRB 4600 Foundry Prime - Page 202

DescriptionAction
xx0900000122
Seal all refitted joints with Sikaflex 521FC.3
xx0900000125
Use the tooling pin to even out the surface
of the Sikaflex seal.
4
Sikaflex 521FC skin dry time (15 minutes).Wait 15 minutes.5
3HAC035355-001Use Touch up paint Foundry Prime, grey to
paint the joint.
Note
Always read the instruction in the product
data sheet in the paint repair kit for Foundry
Prime.
6
Apply Mercasol on all screw heads and set
screws after tightening.
7
202 Product manual - IRB 4600 Foundry Prime
3HAC040585-001 Revision: M
© Copyright 2013-2018 ABB. All rights reserved.
4 Repair
4.2.4 Cut the paint or surface on the robot before replacing parts
Continued