ABB IRB 4600 Foundry Prime - Page 341

NoteAction
A
B
C
xx0800000445
Fit a lifting lug in the uppermost hole
for the attachment screws that secure
the lower arm to the gearbox.
14
Parts:
• A: Gearbox axis 2
• B: Lifting lug
• C: Holes for attachment screws that se-
cure the lower arm to the axis-2 gearbox
Secure the gearbox with a roundsling
in an overhead crane or similar.
15
See the figure in:
• Location of gearbox axis 2 on page 336
Remove the attachment screws and
washers that secure the gearbox to the
frame.
16
Guide pin, M12x150: 3HAC13056-2Fit guide pins to help guiding the
gearbox out from the frame.
17
Always use guide pins in pairs.
Note
Always use removal tools in pairs diagonal to
each other.
If necessary, use removal tools to re-
move the gearbox.
18
Remove the gearbox.
CAUTION
Use caution in order not to damage
gearbox or pinion!
19
Refitting gearbox axis 2
Use this procedure to refit the gearbox.
NoteAction
DANGER
Turn off all:
• electric power supply
• hydraulic pressure supply
to the robot, before entering the robot
working area.
1
Continues on next page
Product manual - IRB 4600 Foundry Prime 341
3HAC040585-001 Revision: M
© Copyright 2013-2018 ABB. All rights reserved.
4 Repair
4.8.2 Replacing gearbox axis 2
Continued