Tension Electronics PFEA111/112, User Manual
Section 3.12.4 Zero Set
3BSE029380R0101 Rev C 3-15
3.12.4 Zero Set
Zero set is used to compensate for load cell zero signal and tare weight.
The zero setting range is ±2 x F
nom
(load cell nominal load).
Figure 3-9. Zero Set Menus
NOTE
Zero set must be done with no tension applied to the roll.
SetObject
FastSetUp
WebTension
Presentation-
Menu
NominalLoad
ServiceMenu
ZeroSet
SetWrapGain
> 5 s
CurrentOutput
VoltageOutput
Miscellaneous
Menu
ZeroSet AreYouSure ActionDone
(shown for 1 s.)
From NominalLoad
To SetWrapGain
To Next Page
Loading...
