Tension Electronics PFEA111/112, User Manual
Chapter 6 Fault-tracing
6-4 3BSE029380R0101 Rev C
6.6 Error and Warning Messages in PFEA111/112
An ERROR is something that causes the electronics to function incorrectly.
A WARNING is something that might affect the accuracy of the measurement.
When a warning or an error occurs, a warning or an error message is displayed on the
Operator Panel and the “Status” indication turns from green to red.
When is pressed the message disappears from the display.
If the problem that activated the warning or error message has disappeared the
“Status” indication turns to green.
If the error or warning remains the “Status” indication is red. Use the to step to the last
operator menu, where you can read the error or warning message.
6.6.1 Error Messages
The following errors can be detected:
• Flash (memory) error
• EEPROM (memory) error
• Supply error
• Load cell excitation error
See Section 6.8 Warnings and Errors Detected by the Tension Electronics.
6.6.2 Warning Messages
The following warnings can be detected:
• Profibus communication problem
• Synchronization problem
See Section 6.8 Warnings and Errors Detected by the Tension Electronics.
To Next Page
Loading...
