Tension Electronics PFEA111/112, User Manual
Chapter 6 Fault-tracing
6-2 3BSE029380R0101 Rev C
6.3 Interchangeability
6.4 Necessary Equipment and Documentation
The following items are required to perform fault-tracing and repairs:
• Cable diagrams, see Appendix (B, C, D, E, F or G) for installed load cell type
• Service tools
• Torque wrench
• Multimeter
Unit Measures
Tension Electronics The tension electronics PFEA111/112 is
interchangeable with a tension electronics of the
same type.
A new setup is required.
Load cells The load cells are directly interchangeable
with other load cells of the same type.
Zero setting PFEA111/112 and resetting “Maximum
Load A” or “Maximum Load B” are required after a
load cell has been replaced.
To Next Page
Loading...
