ABB REC650 ANSI - Page 477

Table 386: A4RADR Non group settings (advanced)
Name Values (Range) Unit Step Default Description
NomValue31 0.0 - 999999.9 - 0.1 0.0 Nominal value for analog channel 31
UnderTrigOp31 Disabled
Enabled
- - Disabled Use under level trigger for analog channel 31
(on) or not (off)
UnderTrigLe31 0 - 200 % 1 50 Under trigger level for analog channel 31 in %
of signal
OverTrigOp31 Disabled
Enabled
- - Disabled Use over level trigger for analog channel 31
(on) or not (off)
OverTrigLe31 0 - 5000 % 1 200 Over trigger level for analog channel 31 in % of
signal
NomValue32 0.0 - 999999.9 - 0.1 0.0 Nominal value for analog channel 32
UnderTrigOp32 Disabled
Enabled
- - Disabled Use under level trigger for analog channel 32
(on) or not (off)
UnderTrigLe32 0 - 200 % 1 50 Under trigger level for analog channel 32 in %
of signal
OverTrigOp32 Disabled
Enabled
- - Disabled Use over level trigger for analog channel 32
(on) or not (off)
OverTrigLe32 0 - 5000 % 1 200 Over trigger level for analog channel 32 in % of
signal
NomValue33 0.0 - 999999.9 - 0.1 0.0 Nominal value for analog channel 33
UnderTrigOp33 Disabled
Enabled
- - Disabled Use under level trigger for analog channel 33
(on) or not (off)
UnderTrigLe33 0 - 200 % 1 50 Under trigger level for analog channel 33 in %
of signal
OverTrigOp33 Disabled
Enabled
- - Disabled Use over level trigger for analog channel 33
(on) or not (off)
OverTrigLe33 0 - 5000 % 1 200 Overtrigger level for analog channel 33 in % of
signal
NomValue34 0.0 - 999999.9 - 0.1 0.0 Nominal value for analog channel 34
UnderTrigOp34 Disabled
Enabled
- - Disabled Use under level trigger for analog channel 34
(on) or not (off)
UnderTrigLe34 0 - 200 % 1 50 Under trigger level for analog channel 34 in %
of signal
OverTrigOp34 Disabled
Enabled
- - Disabled Use over level trigger for analog channel 34
(on) or not (off)
OverTrigLe34 0 - 5000 % 1 200 Over trigger level for analog channel 34 in % of
signal
NomValue35 0.0 - 999999.9 - 0.1 0.0 Nominal value for analog channel 35
UnderTrigOp35 Disabled
Enabled
- - Disabled Use under level trigger for analog channel 35
(on) or not (off)
UnderTrigLe35 0 - 200 % 1 50 Under trigger level for analog channel 35 in %
of signal
Table continues on next page
1MRK 511 287-UUS A Section 12
Monitoring
471
Technical manual