Mounting the tabletop hand grips
The pair of tabletop hand grips are used by the operator for moving the
floating tabletop. Using the hand grips will avoid the operator grasping the
table edges which could cause a risk to pinch fingers.
To mount a hand grip:
1. Slide the hand grip in the rails of the tabletop.
2. Mount the stop blocks at the end of the rails to prevent the hand grip from
sliding out of the rail.
Figure 51: Hand grip
142 | DR 400 | Radiographic Table and X-Ray Tube Stand
3231E EN 20210708 1530
To Next Page
Loading...
