Problem solving
Topics:
• Restoring connection between generator and NX after generator failure
• Automatic collimation always too wide or too narrow
• Empty Bucky Failure, Double Exposure Failure
• NX does not connect to the generator due to ID tablet
• No table movement
• DR Detector is Exceeding the Maximum Working Temperature
• DR Detector must be Recalibrated
• System does not start completely if collimator is in manual mode
• Tube head display shows screen to check network connection
• Radiographic Parameter Limits
DR 400 | Problem solving | 205
3231E EN 20210708 1530
To Next Page
Loading...
