Performing an exposure using a CR cassette
Note: Using an ID Tablet to identify cassettes before the exposure
will break the communication of X-ray parameters between the NX
workstation and the X-ray generator console. It is advised to
identify cassettes after the exposure, as described in this workflow.
Topics:
• Step 1: retrieve the patient info
• Step 2: select the exposure
• Step 3: prepare the exposure
• Step 4: check the exposure settings
• Step 5: execute the exposure
• Step 6: repeat steps 2 to 5 for the next subexposures
• Step 7: digitize the image
• Step 8: perform a quality control
80 | DR 400 | Basic Workflow
3231E EN 20210708 1530
To Next Page
