AGFA DR 400 - System Configuration and Components

Configuration
DR 400 is a configurable DR (Direct Radiography X-ray system) or CR
(Computed Radiography) X-ray system.
The complete DR 400 consists of the following components:
• Radiographic table with an integrated Fixed DR Detector or with a bucky.
In the bucky a DR Detector or a CR cassette can be inserted.
• Radiographic wall stand with an integrated Fixed DR Detector or with a
bucky. In the bucky a DR Detector or a CR cassette can be inserted.
• Bucky with integrated battery charger for DR 14s detecors (optional)
• X-ray tube stand mounted on the radiographic table
• X-ray generator integrated in the radiographic table
• X-ray generator mini console
• X-ray tube with manual or automatic collimator
• NX image processing software on the NX workstation
• DR Generator Sync Box (depending on the configuration)
• Automatic Exposure Control (AEC)
• Dose Area Product Meter (DAP, optional)
DR 400 also has a configuration without radiographic wall stand.
Depending on the configuration the following components are also available:
• Portable DR Detector
DR 400 can be used in combination with:
• DX-G
• DX-M
• CR 30-X (5175/2XX)
• CR 30-Xm
• CR 10-X
• CR 12-X
• CR 15-X
DR 400 has three main configurations:
1. DR configuration with X-ray exposure parameter control on the NX
workstation.
2. CR configuration with X-ray exposure parameter control on the NX
workstation.
3. Mixed DR and CR configuration with X-ray exposure parameter control on
the NX workstation.
X-ray parameters are controlled using the Software Console on the NX
workstation.
DR 400 | Introduction to DR 400 | 15
3231E EN 20210708 1530