Unloading of the bucky in the Radiographic Table
To unload the bucky with a cassette or detector:
1. Open the bucky drawer completely by pulling the front handle.
2. Push firmly with both hands the cassette or detector towards the rear
clamp to open the clamping mechanism.
CAUTION:
Make sure your fingers are not between slider and cassette.
The clamping mechanism may hurt your fingers, therefore
take special care.
3. Lift the cassette or detector and remove it from the clamping. The
openings in the carrier allow your fingers to grip the detector or cassette.
4. Load the bucky with another cassette or detector.
• Alternatively, close the bucky drawer using the front handle and
pushing the button to release the brake.
170 | DR 400 | Bucky
3231E EN 20210708 1530
To Next Page
Loading...
