1310 Inlets
Split/splitless inlet
2 of 36
Jun 2001
Illustrated Parts Breakdown
Agilent 6890 Gas Chromatograph Service Manual
Split/splitless inlet
Description Part no. Qty.
1. O-rings HPM8 (10/pkg) 5180-4181 1
2. Septum nut 18740-60835 1
3. Septum, 11 mm, solid, (25/pkg)* 5181-1263 1
4. Nut, Merlin Microseal 5182-3445 –
5. Septum, Merlin Microseal 5182-8815 –
6. Top insert assembly (EPC), original
New insert assembly (EPC, new trap)
(Manual assy)
New sampling valve/Split-Splitless insert assembly
G1544-60575
G1544-60585
19251-60575
G1580-60585
1
1
1
7. O-ring,*.239-inch (Order No. 5180-4182, 12/pkg) 0905-1014 1
8. Inlet liner, split mode, standard** 5183-4647 1
9. Split vent flow line (14.2-inch long x 0.125-inch id) G1544-20620 1
10. Split vent trap assembly***
Replacement filter cartridge kit (2/pkg)
G1544-80550
G1544-80530
1
–
11. Swagelok nut, 1/8-inch brass (10/pkg) 5180-4103 1
12. Swagelok back ferrule, 1/8-inch brass (10/pkg) 5180-4115 1
13. Swagelok front ferrule, 1/8-inch brass (10/pkg) 5180-4109 1
14. Screw, M4 x 12 mm, Torx T-20 (Captive) 1390-1023 3
15. Inlet weldment G1544-80570 1
16. Heater/Sensor assembly G1544-61140 1
17. Screw, M4 x 8 mm, Torx T-20, chromeplated 0515-2711 3
18. Top insulation G1544-00010 1
19. Washer, 12/pkg 5061-5869 1
20. Thermal block G1544-20570 1
21. Block insulation G1544-00020 1
22. Thermal nut G1544-20590 1
23. Lower inlet seal, gold plated
Also in stainless steel (optional)
18740-20885
18740-20880
1
–
24. Flat thrust washer (Order no. 5061-5869, 12/pkg) 2190-0464 1
25. Reducing nut 18740-20800 1
26. Insulation, (lower) G1544-00030 1
27. Insulation, order qty 3 19243-00067 3
28. Bottom insulation cover 19243-00070 1
29. Ferrules (identify by internal diameter):*
Solid (no hole) ferrule plug
Graphite ferrule 0.5 mm id (10/pkg)
Graphite ferrule 1.0 mm id (10/pkg)
5181-7458
5080-8853
5080-8773
1
30. Column nut* (Order no. 5181-8830, 2/pkg) 18740-20870 1
31. Screw, M3 x 16 mm, Torx T-10 1390-1022 1
32. Plastic fitting, HPM8, (10/pkg) 5181-3394 1