Agilent Technologies 6890 Series Service Manual

210 Split/Splitless Inlet
Leak testing the EPC module only
30 of 30
Jun 2001
Inlets
Agilent 6890 Gas Chromatograph Service Manual
Potential leak points
Check the following areas when checking an inlet system for leaks.
In the oven
Make sure the bottom of the inlet is correctly capped.
On the inlet
• Septum
• O-ring in top of inlet
• Lower inlet seal at bottom of inlet
At EPC module
• Three O-rings behind block where the inlet’s pneumatic lines enter
module
• Two O-rings for each valve
• Septum purge cap

Agilent Technologies 6890 Series Specifications

General

Brand	Agilent Technologies
Model	6890 Series
Category	Laboratory Equipment
Language	English