120 User Information
Running a Sample
Running a Sample
To run a sample, perform the following:
1 Make sure the gas supplies have sufficient gas available for
all of the analyses.
2 Set the flow and pressures for the Headspace Sampler. See
page 121.
3 Set the GC conditions. See the GC operating manual.
4 Load the method or set the method chain. See Loading a
method on page 103 or Activate a Method Chain on page 104.
5 Prepare the samples. See Sample Preparation on page 90.
6 Load the samples into the tray. See page 92.
7 When the GC and HS are ready, press Start.
medium_standard.book Page 120 Tuesday, February 17, 2004 10:14 AM
To Next Page
Loading...
Need help?
General
