Agilent Technologies G1888 User Manual

130 User Information
Maintaining the Instrument
Removing the Loop Cover
Remove the loop cover to gain access to most of the user
serviceable parts. Follow the steps in Table 10.
Tabl e 10 Removing the loop cover
Step Action Notes
1 Open the pneumatics cover. a Raise the lid of the sampler.
b Use a Phillips screwdriver to loosen
the two screws at the front of the
sampler cover shown below.
c Lower the lid of the sampler.
d Raise the pneumatics cover.
Screws
medium_standard.book Page 130 Tuesday, February 17, 2004 10:14 AM

Agilent Technologies G1888 Specifications

General

Brand	Agilent Technologies
Model	G1888
Category	Laboratory Equipment
Language	English