Agilent Technologies Truevolt Series - Page 151

DISPlay:TEXT:CLEar
Clears the text message from the display.
Parameter Typical Return
(none) (none)
Clear displayed message:
DISP:TEXT:CLE
l With DISPlay ON, DISP:TEXT:CLEar returns the display to its normal mode.
l With DISPlay OFF, DISP:TEXT:CLEar clears the message and the display remains disabled. To enable the display,
send DISPlay ON or press the front-panel [Local] key.
l The display text is unaffected by *RST. It is cleared at power-on.
DISPlay:VIEW {NUMeric|HISTogram|TCHart|METer}
DISPlay:VIEW?
Specifies whether measurement data is displayed in numeric, histogram, trend chart (34461A only), or bar meter
form.
Parameter Typical Return
{NUMeric|HISTogram|TCHart|METer}, default NUM HIST
Display histogram:
DISP:VIEW HIST
l This command does not turn on the display if the display state is OFF.
l This parameter is set to its default value after a Factory Reset (*RST) or Instrument Preset (SYSTem:PRESet).
Agilent Truevolt Series DMM Operating and Service Guide 151