Agilent Technologies Truevolt Series - Page 164

LXI:RESet
Resets LAN settings to a known operating state, beginning with DHCP. If DHCP fails, it uses Auto-IP. This command
also clears the Web Interface password.
Parameter Typical Return
(none) (none)
Reset the LANsettings:
LXI:RES
l Depending on your network, the LAN interface may take several seconds to restart after this command is sent.
l If the LAN interface or specific LAN services (VXI-11, sockets, and so on) have been disabled by
SYSTem:COMMunicate:ENABle, you must separately re-enable the interface or services and cycle instrument
power for the LAN to be operational.
LXI:RESTart
Restarts the LAN with the current settings as specified by the SYSTem:COMMunicate:LAN commands.
Parameter Typical Return
(none) (none)
Restart the LANinterface:
LXI:REST
l Depending on your network, the LAN interface may take several seconds to restart after this command is sent.
l If the LAN interface or specific LAN services (VXI-11, sockets, and so on) have been disabled by
SYSTem:COMMunicate:ENABle, you must separately re-enable the interface or services and cycle instrument
power for the LAN to be operational.
164 Agilent Truevolt Series DMM Operating and Service Guide