SYSTem:HELP?
Returns a complete list of the instrument's SCPI commands.
Parameter Typical Return
(none) (see below)
Return the list of SCPI commands:
SYST:HELP?
l The query returns Definite Length Block Data, which allows any type of data to be transmitted as a series of 8-bit
data bytes. The first line is a pound sign (#) followed by one digit representing the number of digits in the decimal
integer to follow. This digit is followed by a decimal integer indicating the number of data bytes to follow, followed
by the first New Line. (For example, "#47947" in the first line means that there are 7947 data bytes to follow.)
The rest of the block has one command per line, each terminated by a New Line character (ASCII character 10).
The beginning of a returned list is shown below. Note that the actual contents may vary, depending on the
firmware revision:
#48085
:ABORt/nquery/
:CALibration:ADC?/qonly/
:CALibration:ALL?/qonly/
:CALibration:COUNt?/qonly/
:CALibration:DATA
In this list,
l /nquery/ indicates a command with no query.
l /qonly/ indicates a query with no command form.
l All other commands consist of a command and query.
l Syntax for each command is found in the Command Quick Reference.
l The list may include commands or queries not described in this document. These are deprecated commands
included for compatibility with older instruments.
Agilent Truevolt Series DMM Operating and Service Guide 233
To Next Page
Loading...
Need help?
General
