SYSTem:ERRor[:NEXT]?
Reads and clears one error from the error queue. See SCPI Error Messages for the complete SCPI error message list.
Parameter Typical Return
(none) -113,"Undefined header"
Read and clear the first error in the error queue:
SYST:ERR?
l Up to 20 errors can be stored in the instrument's error queue. Each remote interface I/O session (GPIB, USB, VXI-
11, Telnet/Sockets) has its own interface-specific error queue. Errors appear in the error queue of the I/O session
that caused the error. For example, if an error was generated by a command sent over GPIB, send
SYSTem:ERRor? from GPIB to read the error queue. Errors generated by instrument hardware are broadcast to all
I/O sessions.
l Error retrieval is first-in-first-out (FIFO), and errors are cleared as you read them. The instrument beeps each time
an error is generated (unless disabled by SYSTem:BEEPer:STATe OFF).
l If more than 20 errors have occurred, the most recent error stored in the queue is replaced with -350,"Queue
overflow". No additional errors are stored until you remove errors from the queue. If no errors have occurred when
you read the error queue, the instrument responds with +0,"No error".
l Errors have the following format (the error string may contain up to 255 characters).
<error code>,<error string>
Where:
<error code> = a positive or negative integer
<error string> = a quoted ASCII string up to 255 characters
See Also
*SRE
232 Agilent Truevolt Series DMM Operating and Service Guide
To Next Page
Loading...
Need help?
General
