SYSTem:BEEPer:STATe {ON|1|OFF|0}
SYSTem:BEEPer:STATe?
Disables or enables the beep heard during continuity, diode, or Probe Hold measurements, or when an error is
generated from the front panel or remote interface.
Parameter Typical Return
{ON|1|OFF|0}, default ON 0(OFF)or1(ON)
Disable beeper state:
SYST:BEEP:STAT OFF
l This command not affect the front-panel key click.
l A beep is always emitted (even with beeper state OFF) when SYSTem:BEEPer is sent.
l This setting is non-volatile; it is not changed by power cycling, a Factory Reset (*RST), or an Instrument Preset
(SYSTem:PRESet).
SYSTem:CLICk:STATe {ON|1|OFF|0}
SYSTem:CLICk:STATe?
Disables or enables the click heard when a front-panel key or softkey is pressed.
Parameter Typical Return
{ON|1|OFF|0}, default ON 0(OFF)or1(ON)
Disable keyboard click:
SYST:CLIC:STAT OFF
l This command not affect the beeper heard associated with diode and continuity tests, errors and so on.
l This setting is non-volatile; it is not changed by power cycling, a Factory Reset (*RST), or an Instrument Preset
(SYSTem:PRESet).
SYSTem:DATE <year>, <month>, <day>
SYSTem:DATE?
Sets the date for the instrument's real-time clock. Use SYSTem:TIME to set the time.
Parameter Typical Return
<year 2000 to 2099
<month> 1 to 12
<day> 1 to 31
+2011,+07,+26
Set system date to July 26, 2011:
SYST:DATE 2011, 7,26
l The real-time clock is used for Mass Memory (MMEMory) system file timestamps.
l The real-time clock is battery-backed and retains the date and time when power is off.
l The date and time are not affected by *RST or SYSTem:PRESet.
l The real-time clock does not adjust itself for time zone changes or daylight savings time. Be sure to set the date
and time when you first receive your instrument.
Agilent Truevolt Series DMM Operating and Service Guide 231
To Next Page
Loading...
Need help?
General
