LAN Services
LAN Services enables and disables the LAN services shown below.
USB Settings
USB Settings configures the front-panel USB (storage) and rear-panel USB (connectivity) connectors.
The ability to enable or disable the front-panel USB interface requires the SEClicensed option. This can be
ordered as factory option 34460A-SEC or as customer-installable option 3446SECU. Without this option,
the front-panel USB interface is always enabled.
USB Front
USB Front enables or disables the instrument’s front-panel USB host port.
USB SCPI
USB SCPI enables or disables the rear-panel USB control port. After changing the interface state, cycle instrument
power to make the change take effect. When disabled, the interface cannot be configured by the Agilent IO Libraries
Connection Expert utility.
74 Agilent Truevolt Series DMM Operating and Service Guide
To Next Page
Loading...
Need help?
General
