Akai DPS16

121
Chapter 10: Project Management (Project Mode)
The following screen appears.
1
2
1 Approx. time
Indicates approximate time taken until the backup operation is completed. This estimate is calculated based
on the sampling rate of 48kHz.
2 Sampling rate (32kHz/44.1kHz/48kHz)
Enables you to select a sampling rate used for recording to a connected DAT recorder.
5. In the Sampling rate field (2), select a sampling rate (32kHz/44.1kHz/48kHz) used for recording to
a connected DAT recorder.
6. Press the [F5] (DO IT) key.
The following screen appears.
7. Start recording on the DAT recorder, and press the [F6] (START) key on the DPS16.
The backup operation starts. When it is completed, the display returns to the Project screen.
Press the [F1] (CANCEL) key to cancel the backup operation in step 6.
CAUTION : Do not monitor the audio via the DAT during the backup operation. Since audio and other
data is transmitted as a digital signal, an attempt to monitor it may damage the speakers.