163
Chapter 13: Using the Effects
PITCH SHIFT
This effect has a pitch shift with a range of +/– one octave, and can be set for the left channel and the right channel
independently.
1
2
3
4
5
6
Parameter Setting range Function
1 Left *1 –12.99 – +12.99 Adjusts the amount of pitch shift for the L channel.
2 Fdback *2 0 – 127 Adjusts the amount of delay that is fed back on the L channel.
3 Right *5 –12.99 – +12.99 Adjusts the amount of pitch shift for the R channel.
4 Fdback *6 0 – 127 Adjusts the amount of delay that is fed back on the R channel.
5 Balance +50 – 0 – –50 Adjusts the balance between the effect sound and dry sound. (Effect
sound only at a value of +50)
6 Effect ON/OFF Switches the effect sound output on and off.
ROTARY SPEAKER
This stereo-out effect simulates rotary speakers for organ sound. Use MIDI Control Change messages (input from
the MIDI IN port or the [F4] (MANUAL) key) to switch between two rotation speeds (Rate1/Rate2).
1
2
3
4
5
6
7
8
Parameter Setting range Function
1 Rate1 *1 0.1Hz – 10.0Hz Adjusts the rotation speed (Rate1) of the speakers.
2 Rate2 *2 0.1Hz – 10.0Hz Adjusts the rotation speed (Rate2) of the speakers.
3 Accel *3 0.1sec – 10sec Adjusts the time (duration) taken for switching from Rate1 to Rate 2.
4 Init *4 R1/R2 Sets the initial rotation speed (Rate1/Rate2).
5 MIDIch *5 1 – 16 Selects a MIDI channel that receives Control Changes messages.
6 CtrlNo. *6 0 – 127 Sets a Control Change number to be received.
7 Balance +50 – 0 – –50 Adjusts the balance between the effect sound and dry sound. (Effect
sound only at a value of +50)
8 Effect ON/OFF Switches the effect sound output on and off.
To Next Page
Loading...
Need help?
General
