Akai DPS16 User Manual

147
Chapter 13: Using the Effects
3. Move the cursor to the target parameter and turn the [JOG] wheel to change the value.
✐ TIPS:
• If you set QLMC’s “mode” to “EFFECT” and “panel” to FX1–4, you can adjust some parameters of
the target effects using QLMC ( [C1] – [C6] knobs).
• You can also use the [F3] key to toggle between two parameter screens of some effect types.
4. When you finish setting the parameters, press the [F1]( EXIT) key to return to the Effect screen.
Controlling the effect parameters using the QLMC section
When the Main screen or a Mixer mode screen is displayed, the
QLMC (Q-Link Mixer Control) section appears on the right of the
display.
QLMC is a function that directly controls the DPS16’s mix param-
eters and effect parameters. Six knobs ([C1]-[C6]) on the right side of
the display correspond to the parameters shown on the display, and
are used to adjust the parameters during recording or playback.
1. While the main screen or a
Mixer mode screen is displayed,
press the [F5] key to select
“ EFFECT” as the QLMC mode.
While the main screen or a Mixer
mode screen is displayed, pressing
the [F5] key enables you to select a
QLMC mode from “MIXER”
(controlling mixer parameter) and
“EFFECT” (controlling effect
parameters).
C1
C3
C5
C2
C4
C6
[F5] key

Akai DPS16 Specifications

General

Brand	Akai
Model	DPS16
Category	Recording Equipment
Language	English