Akai DPS16

171
Chapter 13: Using the Effects
REVERB>LIVE HOUSE
This stereo reverb effect simulates reverberations in a live house.
1
2
3
4
5
6
7
8
Parameter Setting range Function
1 Pre-D *1 1ms – 100ms Adjusts the delay time of early reflections.
2 Time *2 0.1sec – 10sec Adjusts the time of attenuation of reverberation.
3 Diff *3 0 – 127 Adjusts the density of reverberation.
4 HFdamp *4 20Hz – 20kHz Sets a frequency at which the higher range of reverberation is cut.
5 Near *5 0 – 127 Adjusts the imaginary distance to the sound source. Lower the value is,
more depth and distance.
6 Width *6 0 – 127 Adjusts the width and spread of the stereo image.
7 Balance +50 – 0 – –50 Adjusts the balance between the effect sound and dry sound. (Effect
sound only at a value of +50)
8 Effect ON/OFF Switches the effect sound output on and off.
REVERB>MEDIUM HALL
This stereo reverb effect simulates reverberations in a medium-size hall.
1
2
3
4
5
6
7
8
Parameter Setting range Function
1 Pre-D *1 1ms – 100ms Adjusts the delay time of early reflections.
2 Time *2 0.1sec – 10sec Adjusts the time of attenuation of reverberation.
3 Diff *3 0 – 127 Adjusts the density of reverberation.
4 HFdamp *4 20Hz – 20kHz Sets a frequency at which the higher range of reverberation is cut.
5 Near *5 0 – 127 Adjusts the imaginary distance to the sound source. The lower the value
is, the more depth and distance.
6 Width *6 0 – 127 Adjusts the width and spread of the stereo image.
7 Balance +50 – 0 – –50 Adjusts the balance between the effect sound and dry sound. (Effect
sound only at a value of +50)
8 Effect ON/OFF Switches the effect sound output on and off.