124
Chapter 10: Project Management (Project Mode)
Reloading from a DAT
1. Use the digital audio COAXIAL cable (that you used for backup) to connect the DIGITAL IN jack on
the rear panel of the DPS16 and the digital output jack on the DAT recorder.
DPS16
DIGITAL OUT
DIGITAL IN
DAT
COAXIAL cable
SHUTTLEJOG
2. On the Project screen, press the [F1] (MORE) key followed by the [F5] (RELOAD) key.
3. Set the Device field to “DAT”.
The following screen appears.
Press the [F6] ( DO IT) key.
The following screen appears and the DPS16 waits for a signal from the DAT recorder.
4. Play the DAT tape that contains the backup data.
When the DPS16 starts receiving data from the DAT recorder, it displays the following screen.
1 Displays the name of the Project being reloaded.
When the reload operation is completed, the display returns to the Project screen.
Press the [F1] (CANCEL) key to cancel the reload operation.
CAUTION :
Do not monitor the audio via the DAT during the reload operation. Since audio and other data
is transmitted as a digital signal, an attempt to monitor it may damage the speakers.
To Next Page
Loading...
Need help?
General
