Akai DPS16

162
Chapter 13: Using the Effects
XOVER PHASER
This is a variation of the STEREO PHASER. The feedback from the L/R channels is input to the opposite
channels.
1
2
3
4
5
6
Parameter Setting range Function
1 Rate *1 0.1Hz – 10.0Hz Adjusts the speed of LFO.
2 Depth *2 0 – 127 Adjusts the depth of LFO.
3 Fdback *5 0 – 127 Adjusts the feedback amount.
4 Width *6 0 – 127 Adjusts the width and spread of the stereo image.
5 Balance +50 – 0 – –50 Adjusts the balance between the effect sound and dry sound. (Effect
sound only at a value of +50)
6 Effect ON/OFF Switches the effect sound output on and off.
PAN PHASER
This effect adds an auto panning effect to the phaser effect sound.
1
2
3
4
5
6
Parameter Setting range Function
1 Rate *1 0.1Hz – 10.0Hz Adjusts the speed of LFO.
2 Depth *2 0 – 127 Adjusts the depth of LFO.
3 Fdback *5 0 – 127 Adjusts the feedback amount.
4 Width *6 0 – 127 Adjusts the panning width.
5 Balance +50 – 0 – –50 Adjusts the balance between the effect sound and dry sound. (Effect
sound only at a value of +50)
6 Effect ON/OFF Switches the effect sound output on and off.