Akai DPS16

178
Chapter 13: Using the Effects
PHASER/DELAY
This monaural effect consists of a phaser effect and a delay effect connected in series.
1
2
3
4
5
6
7
8
Parameter Setting range Function
1 Rate *1 0.1Hz – 10.0Hz Adjusts the speed of LFO for the phaser effect.
2 Depth *2 0 – 127 Adjusts the depth of LFO for the phaser effect.
3 Fdback *3 0 – 127 Adjusts the amount of the phaser effect feedback.
4 Delay *4 1ms – 1500ms Adjusts the delay time of the delay effect.
5 Fdback *5 0 – 127 Adjusts the amount of the delay effect feedback.
6 Bounce *6 ON/OFF Sets whether the delay sound is panned (ON) or not.
7 Balance +50 – 0 – –50 Adjusts the balance between the effect sound and dry sound. (Effect
sound only at a value of +50)
8 Effect ON/OFF Switches the effect sound output on and off.
DISTORTION
This monaural distortion effect distorts input signals. An equalizer is connected to the effect in series.
1
2
3
4
5
Parameter Setting range Function
1 Depth *1 0 – 31 Adjusts the depth of distortion.
2 EQ freq *4 0 – 127 Adjusts the center frequency of the EQ.
3 EQ Gain *5 –15dB – +15dB Adjusts the gain of the EQ.
4 EQ Q *6 0.5 – 10 Adjusts the Q of the EQ.
5 Effect ON/BYPASS Selects whether the effect is enabled (ON) or bypassed (BYPASS).