Akai DPS16

161
Chapter 13: Using the Effects
MONO PHASER
This is a common phaser effect with mono-in and mono-out. You can adjust the pan setting of the effect sound.
1
2
3
4
5
6
Parameter Setting range Function
1 Rate *1 0.1Hz – 10.0Hz Adjusts the speed of LFO.
2 Depth *2 0 – 127 Adjusts the depth of LFO.
3 Fdback *5 0 – 127 Adjusts the feedback amount.
4 Pan *6 L63 – MID – R63 Adjusts the stereo image of the effect sound.
5 Balance +50 – 0 – –50 Adjusts the balance between the effect sound and dry sound. (Effect
sound only at a value of +50)
6 Effect ON/OFF Switches the effect sound output on and off.
STEREO PHASER
This is a phaser effect that adds width and spread to the stereo image.
1
2
3
4
5
6
Parameter Setting range Function
1 Rate *1 0.1Hz – 10.0Hz Adjusts the speed of LFO.
2 Depth *2 0 – 127 Adjusts the depth of LFO.
3 Fdback *5 0 – 127 Adjusts the feedback amount.
4 Width *6 0 – 127 Adjusts the width and spread of the stereo image.
5 Balance +50 – 0 – –50 Adjusts the balance between the effect sound and dry sound. (Effect
sound only at a value of +50)
6 Effect ON/OFF Switches the effect sound output on and off.