39
Chapter 2: Recording on the DPS16
Completing operations on the DPS16
Follow the steps below to turn off the power to the DPS16 and connected peripheral devices after you finish
recording or mixdown.
1. Turn off the power to the monitor system.
2. Make sure that the DPS16’s internal hard disk and the external drive are not accessed. Turn off the
power to the DPS16. Use the Disk Busy field on the Main screen to check to see whether or not the
disks are being accessed. (See page 14 for more information on the Main screen.)
3. Turn off the power to the external drive, sound sources, and other connected peripherals.
✐
TIPS :
• All track audio data and setup data for the Project you were just working on is automatically stored on the
current disk (internal hard disk or the external drive).
• AKAI recommends that you back up important Projects to an external SCSI device or DAT recorder. For
more information, see page 118.
To Next Page
Loading...
Need help?
General
