136
Chapter 12: MIDI Applications
6.
Press the [F1] (TEMPO) key on the same screen.
The DPS16 displays the screen where you can set a tempo map (Project’s tempo information).
7.
Move the cursor to the Tempo field and turn the [JOG] wheel to set the initial tempo of the song.
You can set the tempo in the range between 30 and 300. If a tempo changes during the song, press the [F6]
(INSERT) key to insert new tempo information, and adjust the position and value of the tempo. (See page 105.)
8. Press the [MAIN SCREEN] key to recall the Main screen.
9. Press the [F4] (SELECT) key, then turn the [JOG] wheel to select the SYNC/CLOCK function.
The following fields appear in the positions of the [F1]–[F3] keys.
[F1] [F2] [F3]
10.
Move the cursor to the [F2] key (SYNC parameter) and turn the [JOG] wheel to select “MIDI CLK/
MASTER”.
MIDI clock is selected as a sync signal transmitted from the DPS16.
11.
Press the [F2] key to set the SYNC parameter to “ON”.
Now the DPS16 can transmit the MIDI clock and the Song Position Pointer from the MIDI OUT connector .
[F1] [F2] [F3]
12.
Set the MIDI sequencer so that it will synchronize to the external MIDI clock.
13.
Start recording or playing back on the DPS16.
When you start recording or playing back on the DPS16, it will transmit MIDI clock, and the MIDI sequencer
will synchronize. When you perform a locate operation on the DPS16, it transmits Song Position Pointer, and
the MIDI sequencer will synchronize from the corresponding point in a song.
To Next Page
Loading...
Need help?
General
