156
Chapter 13: Using the Effects
5. Move the cursor to the right side of the knob indicated in the Send 1 field and adjust the level of
signal sent to FX1. Usually, set the level to the maximum (127).
✐
TIP :
With some effects, the result may vary depending on the input level. If you are using such an effect
on multiple channels, change the SEND level to adjust the level of the signal input to the effect.
6. While playing the DPS16, adjust the effect parameters, if necessary.
7. When you are ready, start mixdown.
➸
NOTES :
• If you set an effect to “INS ”, you will not be able to use it for other inputs, TRACK MIX channels, or
AUX sends.
• If the signal output from the inserted effect is stereo, the stereo signal will be sent to the Master bus.
✐
TIPS:
• If you insert two effects of the same type to two channels, you can use them as stereo-in/out effects. For
example, you can apply the compressor to the stereo drums tracks during mixdown.
• Compressor, expander, and noise gate effect types offer a LINK parameter that allows FX2 to use the
edited FX1 effect parameters. They are useful when you wish to use the same effect type for two chan-
nels.
To Next Page
Loading...
Need help?
General
