157
The upper half of the window shows narrow versions of the Tracks in that Sequence. They are for visual
reference only and are not editable.
The lower half of the window can contain two kinds of channel faders:
• Tracks, to the right of the grey Tracks separator (if Tracks are shown). Their functions are
described in the following sections of this chapter. By default used Tracks are named Track 01,
Track 02, etc.
• Programs, to the right of the grey Programs separator (if Programs are shown). These work the
same way as described in Main Mode > Program Channel Strip.
This section works like a regular mixer with various settings for each channel strip. You can use the
Tracks' channel strips and Program Channel strips together to create a good mix of the Sequences in
your Project.
The controls on the right-most side of this area are the Send Effects, Submix, and Master FX panels (if
visible).
To view more mixer channels, use the scroll bar under the channel faders at the bottom of the window.
Show/Hide Buttons
You can show or hide unused Tracks' channel strips (i.e., those with no note events) and/or plugins
through which your Tracks are routed:
• To show or hide the Send Effects, Submix, and Master FX panels, click the downward
arrow icon to the left of the channel strips.
• To show or hide all Tracks' channel strips, click the channel strip icon to the left of the
channel strips.
• To show or hide unused Tracks' channel strips, click the + icon to the left of the channel
strips or in the upper-left corner of the grid.
• To show or hide the Programs' channel strips for the Tracks, click the plug icon to the left
of the channel strips or in the upper-left corner of the grid.
• To show or hide unused Programs' channel strips for the Tracks, click the plug icon to the
left of the channel strips or in the upper-left corner of the grid.
To Next Page
Loading...
Need help?
General
