317
Sample Edit Mode
General
The sample timeline above the sample waveform now lets you select
whether it is shown in Beats (which displays as bars.beats.ticks) as well
as the previously available Time (which displays as seconds:milliseconds)
or Samples. To set this, click the left-most part of the timeline or right-click
any other place of the timeline.
When you enter Sample Edit Mode, the sample currently selected in Project Information will
automatically appear in the sample waveform for editing.
When you press a pad in Main Mode, the sample assigned to Layer 1 will be selected in Project
Information.
Hardware Tip: To quickly prepare a sample to edit, press its assigned pad (if it's assigned to the pad's
Layer 1) and then press Sample Edit to enter Sample Edit Mode.
Hardware: When adjusting the start point, end point, or loop point of a sample or slice, turning the Data
Dial to change the value is now scaled based on the zoom level. Zoom in for very fine sample-level
control or zoom out for coarser adjustments.
To Next Page
Loading...
Need help?
General
