178
Sample Rec and Sample Stop
Important: To use the Assign to Pad function to assign the new sample directly to a pad after recording,
select the desired Track and Program before starting to record.
Click Sample Rec to record-arm the software, or click Sample Stop to stop the
recording process. If you do not click Stop, recording will continue to the end of the
previously set sample length.
After clicking Sample Rec, the recording will start once the incoming audio level
exceeds the Threshold parameter.
Hardware:
1. To start recording, press F6 (Record).
2. After that, the recording will start once the incoming audio level exceeds the Threshold parameter.
3. If recording has not begun yet, you can cancel the procedure by pressing F5 (Cancel) or start the
recording immediately by pressing F6 (Start).
4. To stop recording, press F6.
When the recording is finished, the Keep or Retry Last Sample
window appears:
• If you want to keep the recorded sample, enter a name in
the New Name field.
• Click the Track menu to select a Track to assign the
sample to.
• Click and drag the Assign to Pad field to select a pad to
assign the sample to.
Important: You need to have already selected the Track to
which you want to assign the pad. If the Track is not the
one you wanted, either move the sample to the desired
Track or Program later, or select Retry to start over.
• Click and drag the Root Note field to set where the
sample's original pitch will be on the keyboard.
• To save the sample, click Keep. To delete the recording
and start over, click Retry. To listen to the sample before
deciding, click Play.
To Next Page
Loading...
Need help?
General
