367
Sample Edit Mode
Trim Mode
While using Trim Mode, you can now play the sample as a continuous
loop while simultaneously adjusting its start and end points. This is
useful if you don’t want to keep playing the sample each time you
make an adjustment.
To continuously play or stop the sample, click Pad 16 (Play Loop
Continuous).
Program Mode
While using Program Mode, you can quickly load a single slice (or all
slices) to a pad along with the current start point, end point, and other
settings.
To load a slice to a pad with the current settings:
1. Press the desired pad on your MPC hardware.
2. Click and drag the Slice menu up or down to select the desired slice.
3. Make sure the other settings (start point, loop point, end point,
etc.) are what you want.
4. Click the To Pad button. The pad will now use those settings from
that slice, and the pad will now use Pad Parameters instead of
Non-Destructive Slice. (In other words, in Program Edit Mode, the
pad’s Slice menu in its Layers section will be set to Pad instead of
a slice number. Also, it will use the start point, end point, and loop
point you set in Step 3.)
To Next Page
Loading...
Need help?
General
