118
Sequence Section
The Sequence section gives you an overview of parameters relevant to
the current Sequence.
In the software, click the Sequence drop-down menu and select a
Sequence or click the icon in the lower-right corner of the drop-down
menu and select an unused Sequence from the list that appears.
Hardware: Move the cursor to Seq and use the Data Dial or the -/+
buttons to select the desired Sequence.
Click the Loop button to switch the Sequence's loop function On or Off.
The loop points are defined by the First and Last Bar values. With the First Bar and Last Bar you can
set the corresponding bar position pointer (e.g., to create a cycle for a loop). Keep in mind that the Last
Bar value depends on the total length of the Sequence.
Hardware: Use the Cursor Buttons to select the Loop field and use the Data Dial or the -/+ buttons to
turn the loop On or Off. With the Loop field still selected, press the Window button. Then, use the
Cursor Buttons to select the field for First Bar, Last Bar, or Number of Bars, and then use the Data
Dial or the -/+ buttons to select the desired numbers.
Click the Total Bars field to set the total number of bars.
Hardware: Use the Cursor Buttons to select the Bars field, and then use the Data Dial or the -/+
buttons to set the desired bar length of your Sequence. You can set up to 999 bars.
Click the T Correct (Time Correct) drop-down menu and select the note quantization value.
Hardware: Press the F1 button (T.C.) to edit the Time Correct value.
Click the Time Sig field to change the time signature for your Sequence.
To Next Page
Loading...
Need help?
General
