316
To play or stop the loop, click Play in the Looper section.
Hardware: To play or stop the loop, press F4 (Play).
To reverse loop playback, click
Reverse in the Looper section. If Seq
Sync is on, playback will reverse once the looper's playhead reaches the
end of the loop. If Seq Sync is off, playback will reverse immediately.
Hardware: To reverse loop playback, press F3 (Reverse). If Seq Sync is
on, playback will reverse once the looper's playhead reaches the end of
the loop. If Seq Sync is off, playback will reverse immediately.
To erase the loop, click Clear in the Looper section. The loop will be erased immediately.
Hardware: To erase the loop, press and hold Shift, and then press F6 (Clear). The loop will be erased
immediately.
To export the loop as a sample:
1. Click Export in the Looper section to open the Export
Loop as a Sample window.
2. Click the New Name field and enter a name for the
sample.
3. Optional: Click the Program drop-down menu and
select a Program to assign it to. To ignore this feature,
select <none>.
4. Optional: If you're assigning the sample to a Program, click and drag the Assign to Pad field up or
down to select the desired pad. To ignore this feature, select Off.
5. Click and drag the Root Note field up or down to select the sample's root note.
6. Optional: Click and hold Play to play the sample.
7. Click Do It to confirm your choice or Cancel to cancel.
When your loop is done exporting, it will appear under Project Information with the name you
entered and will be assigned to the Program and pad you selected (if any).
To Next Page
Loading...
Need help?
General
