228
To load a pad/keygroup insert effect in Program Mixer Mode:
1. In the software, click the Program Mixer tab in the Mode Tab Section.
2. If the Route button above the desired pad is not already selected, click it. Also, if
the Inserts button is set to Off, click it so it changes to On.
3. In one of the four Inserts slots of the channel strip, click the downward arrow ().
4. Select an effect from the menu that appears.
Hardware: To load a pad/keygroup insert effect in Program Mixer Mode:
1. Enter Program Mixer Mode by pressing the Prog Mix button.
2. Press F5 (Insert) to view the pads' insert effect slots. (You can repeatedly press
F5 (Insert) to cycle through the four available insert effect slots. The small squares
below the tab indicate the current slot.)
3. Press the desired pad, or use the Cursor Buttons to select the desired pad. (To
show another set of 16 pads, use the Pad Bank buttons to select another bank.)
4. Use the Data Dial or the -/+ buttons to select an effect. Click F4 (Select) to load
it, or click F3 (Back) to close the page.
To Next Page
Loading...
Need help?
General
