336
Hardware: New Program With New Samples will create new samples from the current one and assign
them to pads in a new Program. The new Program will be named after the sample and appended with
ch. The new samples will be appended with SI-# (where # is a consecutive number). This is similar to
applying the Convert process in v1.7 and selecting Sliced Samples with Create New Program
selected.
• Convert To: This will be set to New Program With New Samples. You can use this field to to select a
different conversion/assignment process.
• Crop Samples: Set this to On to delete the unused parts from the samples when they're created
and assigned. This feature is destructive (though the Project will still contain your original sample).
• Set this to Off to keep the unused parts of the samples when they're created and assigned. This is
essentially like editing samples in Trim Mode and assigning them to pads, but this method creates
new samples, so you will still be able to further edit the entirety of each sample even though you are
using only part of it at the moment.
• Create New Program: Set this to On to create a new Program in which each slice results in a
sample and is automatically assigned to a pad. The new Program will be named after the sample and
appended with ch.
• Create Events (available only if Create New Program is On): Set this to On to create a new
Program in which each slice results in a sample and is automatically assigned to a pad. Furthermore,
it will automatically create a new Track in which each pad plays its corresponding slice in ascending
sequence by pad number.
• Number of Bars (available only if Create Events is On): This field determines how many bars the
slices' events will occupy.
Press F5 (Do It) to confirm your choice or F4 (Cancel) or cancel the operation.
New Program With New Samples in the MPC hardware display.
To Next Page
Loading...
Need help?
General
